Sikafloor 94 100% Solid Low Viscosity Epoxy Primer
Two-part, 100% solids epoxy primer and general-purpose binder resin
- Excellent penetration for concrete surfaces and Sikafloor resin systems.
- Used for epoxy mortars, coving mixes, scratch and flow coats.
- Coverage as a primer approximately 5–6m²/L on CSP 2–3
Uses
- Primer for concrete surfaces with Sikafloor resin systems.
- Binder resin for Epoxy mortar Sub-fill mortar screeds.
- Binder for epoxy Coving mixes.
- Flow and scratch coat layering prior to Sikafloor systems.
Advantages
- Low viscosity
- Excellent substrate penetration
- Very low odour - VOC
- Excellent binder for mortars
- Fast to cure
- Can be accelerated with Sikafloor Booster
- Economical
- Good Chemical Resistance
Colour
Yellowish transparent
Packaging
Available in proportioned 30L
Part A+B
Application Info
Mixing ratio
Part A Part B = 2 :1 (by Mass and Volume)
Ambient air temperature
Application range recommended +5 to +30 Degrees C
Pot Life
10 Degrees C - 30 mins.
20 Degrees C - 20 mins.
Waiting time to overcoating
10 degrees C 15 hours
20 degrees C 8 hours
Note: Waiting times are approximately halved with the addition of Sikafloor Booster
Consumption
Primer
CSP 2-3 profile 5-6m2 L approx.
CSP 4-5 profile 2-3m2 L approx.
Mortar
Range of 1:5 to 1:8 mixed litre of Sikafloor®-94 to kg blended silica sands
Mixing
Part A and B to be mixed the correct ratio for a minimum of 2 minutes
Application
Primer
Roll product evenly on and into the surface.
If the product is completely absorbed then an additional coat should be applied within 24 hours.
Mortar
When used as a binder in Profiling screeds or Coving mixes, the substrate should also be primed with Sikafloor®-94
Colour Accuracy Disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.
Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.
What Our Customers Say
See what trade professionals, contractors and customers have to say about their experience with ProTrade Warehouse.
