Dulux Luxafloor WB - Waterborne Epoxy Floor Coating
Luxafloor WB is a low build, waterborne, two pack epoxy floor coating that provides a hardwearing gloss finish that is easy to clean. It is ideal for areas subject to foot traffic and rubber-tyred vehicle traffic.
This waterborne epoxy coating is suitable for commercial car parks, internal floors, and other areas where odour-sensitive environments require a low VOC, low odour solution. It can also be applied as a slip-resistant finish using Luxafloor Stir-In Aggregate Fine.
Features
- Very tough film – suitable for commercial car parks
- Waterborne, low VOC – less than 10g/L – and low odour
- Excellent adhesion to concrete
- Good chemical resistance
- Gloss finish that is easy to clean
- Available in a range of factory-made and tinted colours, plus clear
Resistance Guide
- Weatherability: Epoxy coatings yellow with time and chalk on exterior exposure. Neither yellowing nor chalking detracts from the protective properties of the coating.
- Solvents: Good resistance to splash and spillage of aromatic and aliphatic hydrocarbon solvents and alcohols.
- Water: Excellent resistance to fresh and salt water but not suitable for immersion.
- Heat Resistance: Up to 120°C dry heat.
- Alkalis: Good resistance to splash and spillage of most common alkalis.
- Salts: Excellent resistance to neutral and alkaline salts.
- Abrasion: Excellent when fully cured.
- Acids: Good resistance to splash and spillage of dilute acids.
- Adhesion: Excellent adhesion to concrete when fully cured.
Finish
Gloss
VOC Level
<10 g/L
Pot Life
1 hour 45 minutes (10 litre kit, 25°C)
Mixing Ratio V/V
Part A: 3, Part B: 1
Download datasheets for full product & application information.
