Nutech Seal Repair Solution
Seal Repair Solution has been developed by Nutech Paint as an effective means to rectify and reinvigorate old and damaged solvent based acrylic sealed concrete floors.
In some instances, Seal Repair Solution may be a cost-effective way to restore an old acrylic concrete sealer without the need to refinish.
Typical Applications
Typical projects include: Any sound old acrylic sealed flooring project requiring refurbishment.
Appearance
Clear water white liquid.
Coverage / Spread Rate
1 - 2 m²/L
Substrate Note
All surfaces must be clean, in sound condition and dry. Remove all oil, dirt, grease, flaking paint and contamination. Improperly prepared surfaces may result in coating failure.
Application
Brush or Roller
Procedure
Old Acrylic Sealer in Poor condition:
- Apply Seal Repair Solution in accordance with the outlined procedure.
- Application of an additional coat of PaveCoat is recommended to provide maximum UV protection and durability.
Recently Applied Acrylic Sealer (delamination & blooming):
- Apply Seal Repair Solution in accordance with the outlined procedure.
- Re-sealing may not be required providing that the surface is not tacky after treatment.
Note: For best results - Thoroughly liquify all layers of old sealer on the surface. Allow approx. 1 litre of solution per 2 - 3m² of surface area. An increased level of solution in warmer weather may be required due to high evaporation.
The following method of application is recommended:
- Surface must be free of grease, oil, dirt and contamination. Clean with Nu-Ecosafe Degreaser in accordance with the TDS.
- Ensure surface is completely dry prior to application of Seal Repair Solution.
- Liberally pour the Seal Repair Solution on the surface, starting at the most elevated position.
- Using a solvent resistant broom or mechanical scrubber, work the solution thoroughly into the surface in 2 - 3m² work areas. For best results, work each area twice to ensure that all sealer is completely liquified.
- Evenly distribute liquified sealer before moving to the next area. Where practical, avoid sealer pooling in mortar or expansion joints.
Allow the surface to dry (approx. 1 – 4 days) prior to pedestrian or vehicle traffic is permitted. Dry time will vary depending on the thickness of the sealer and conditions.
Note: Should the surface remain tacky after the drying period, Nutech Paints recommends the application of a reduced or thin coat of PaveCoat over the entire surface in accordance with relevant TDS.
Read all the datasheets prior to the application or contact us for assistance.
Colour Accuracy Disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.
Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.
