NuTech NuPool Epoxy

NuPool Epoxy - Premium Pool Coating Solution

NuPool Epoxy is a high-build, isocyanate-free gloss pool epoxy coating designed specifically for new or existing concrete and fibreglass pools. This 2-pack swimming pool epoxy system provides robust protection against water, moisture, and a wide range of chemicals. Available in 10 standard colours, Nupool epoxy delivers a sleek, modern finish ideal for both residential and commercial pool projects.

Known for its ease of use and reliable performance, NuPool Epoxy is widely chosen by professionals to rejuvenate worn or damaged pool surfaces. It’s a cost-effective way to extend the life and aesthetic appeal of your pool with a high-quality swimming pool epoxy paint that lasts.

Benefits Of Nupool Pool Epoxy

• Isocyanate Free
• Outstanding chemical resistance
• Excellent adhesion and hardness
• Hard-wearing and resistant to abrasion and corrosion
• Protects against bacterial growth
• Simple application by brush, roller, or spray

Suitable Surfaces

• Concrete Pools
• Fibreglass Pools

Appearance

Opaque or coloured viscous liquid

Coverage Rate

6 – 8 m²/L

Application

Equipment & Tools

• Brush or Roller (refer to TDS for spray equipment)
• Pressure washer and vacuum cleaner
• Drop sheets, cardboard, or old tarps

Preparation

• Degrease the entire pool surface with EcoSafe Degreaser
• Pressure clean thoroughly using a machine rated over 2000 psi
• Remove all stains, oils, and residues. Repeat cleaning if needed
• For bare concrete, etch with EcoSafe Etch and rinse well
• For aged epoxy surfaces, sand or abrade completely
• Repair any chips or cracks
• Vacuum with a soft bristle head to remove all dust and debris
• Set up a safe mixing area using drop sheets or tarps

Coat One

• Mix using the 3:1 ratio by adding NuPool Epoxy Part B into Part A
• Stir thoroughly with a drill mixer
• Add approx. 20% EPiC Epoxy 500 Thinner and mix again
• Let the mixture stand 10 minutes before use
• Use a brush to cut in edges and corners, then roll the remaining surface
• Allow at least 5 hours drying time (temperature dependent)
• Apply the second coat within 72 hours

Coat Two

• Mix the second coat as above
• Let stand 10 minutes before application
• Brush and roll as with the first coat
• Allow to dry for 5 hours (temperature dependent)

Non-Slip Option

For a non-slip finish, broadcast Nutech Coarse Anti-Slip over the second coat while still wet. If used, apply a third coat to encapsulate the anti-slip media.

Curing

NuPool Epoxy requires seven days to fully cure into a hard, durable surface. Keep the pool dry during this period. If moisture contacts the coating, remove water immediately and continue curing.

Download Datasheet to read full application information.

Colour Accuracy Disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.

Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.