Solutions Sealers Silacryl Wet Look | Slate & Porous Stone Acrylic Sealer

Solutions Sealers Silacryl Wet Look is a high-performance, solvent-based acrylic sealer designed to provide a striking wet look finish for slate and other porous stone surfaces. This high solids sealer is crafted for quality and longevity, ensuring your surfaces remain protected and visually enhanced for an extended period.

Suitable for porous stone, It darkens the substrate, enhancing its natural colour and giving it a rich, vibrant appearance. The coating effectively prevents the ingress of oils and dirt, keeping your surfaces clean and well-maintained.

Choose SILACRYL WET LOOK  for a superior wet look finish that not only enhances but also protects your slate and porous stone surfaces with its high solids, solvent-based formulation.

Features:

• Solvent-based wet look sealer
• Suitable for porous stone
• Darkens substrate and enhances colour
• Prevents oils and dirt ingress
• High solids content for long-lasting protection
• colourless

Uses:

Suitable for internal and external use on slate, sandstone, limestone, concrete pavers, and other porous surfaces.

Preparation:

• Always test the product on a small area first and allow a 1-hour cure time to determine the ease of application and suitability for your surface type. For new grout, allow 72 hours before application.
• All surfaces should be thoroughly cleaned with NATURAL CLEAN. Heavily soiled, acid-sensitive surfaces should be cleaned with D-GREASE, while non-acid-sensitive surfaces can be cleaned with D-SCALE. All surfaces should then be neutralized with NATURAL CLEAN.
• Allow the surface to dry for approximately 24 hours before sealing. Ensure the surface is clean and free of residue and other contaminants. Tape or protect nearby surfaces. Ensure proper ventilation and use the appropriate PPE as per the SDS.

Application:

• Apply when the surface temperature is between 5–35°C. Use Solutions Sealers applicator, microfiber, or paintbrush.
• For most porous surfaces, mix the first coat with 50% Eversol (Xylene) to aid adhesion to the substrate.
• 2-3 coats are recommended, with the last coat at 100% strength. Apply the coats slowly without agitation to avoid air bubbles.
• Apply a wet coat without leaving pools of sealer. Seal across the area following the wet line. The sealer will tack off in approximately 15 minutes and be ready for another coat within 1-2 hours.
• Do not allow the sealer to contact painted surfaces, plastic, vinyl, etc.

Coverage:

For porous surfaces, the first coat covers 4-6 square meters per litre; the second and third coats cover 8 and 10 square meters per litre, respectively.

Download and read all the datasheets prior to application.

Visit Solutions Sealer to learn more about this product.

Colour Accuracy Disclaimer: We have taken care to display the most accurate visuals of our products. However, we are not responsible for the colour accuracy of the device you are viewing our swatches on. These variations arise due to different computer monitors and devices (make, model and technology, as well as resolution, contrast and brightness control settings) in much the same way a scan will differ from an original image and a colour photocopy. Furthermore, coatings can exhibit variation in perceived colour depending on gloss level and application method. If you require a very specific colour match, please make your selection via actual swatches and colour boards available at our showroom.

Product Disclaimer: Ensure you read all product, technical and safety data sheets prior to application as liability falls on the applicator. All products must be applied in accordance with manufacturer’s recommended method.